100 to 200 amp service upgrades, breaker box replacement and sub panels for homes that have outgrown their power.
Confirmed on site before work starts
| Panel inspection and load calculation | $0 with quote |
| Breaker box replacement, same amperage | $1,300 – $2,200 |
| 100 amp to 200 amp service upgrade | $1,900 – $3,400 |
| Sub panel installation | $700 – $1,600 |
| Meter base and mast replacement | $900 – $2,100 |
Free quotes on planned work
| Job | Typical range |
|---|---|
| Panel inspection and load calculation | $0 with quote |
| Breaker box replacement, same amperage | $1,300 – $2,200 |
| 100 amp to 200 amp service upgrade | $1,900 – $3,400 |
| Sub panel installation | $700 – $1,600 |
| Meter base and mast replacement | $900 – $2,100 |
You approve the number before we start. No hourly meter running while someone walks to the truck.
Nights, weekends and holidays cost the same as a Tuesday afternoon. Emergencies are expensive enough.
Breakers, outlets, wire, fixtures and panel parts on board, so most calls finish in one visit.
Drop cloths down, holes patched, boxes and offcuts gone. Your house looks like we were never there.
“EV charger and a sub panel in the detached garage. Long run, done neatly in conduit, and they tested it at full amperage before leaving.”
Josh V., Auburn“Panel upgrade from 100 to 200 amps. They pulled the permit, coordinated the power company, and had us back on by four in the afternoon. Clean labeling inside the box too.”
Ray H., Auburn“Warehouse high-bay retrofit, forty fixtures. Worked two nights so our shifts were not interrupted, and the power bill dropped noticeably the next month.”
Derek L., MobileMost Alabama homes land between $1,900 and $3,400 for a 100 to 200 amp upgrade, and $1,300 to $2,200 for a straight breaker box replacement. The spread comes from meter base condition, service mast height and how far the panel sits from the meter. We quote the exact number after looking at it.
Usually four to eight hours for a standard Alabama panel swap. We schedule the utility disconnect for the morning so you are back on before evening, and we can stage a temporary circuit for a refrigerator or medical equipment if you need it.
Yes, and we pull it. Panel and service work in Alabama requires a permit and an inspection, and skipping it causes real problems when you sell or file an insurance claim. Permit and inspection coordination is part of our quote.
For most Alabama homes, yes — including one EV charger, a heat pump and an electric range. If you are planning two chargers, a shop, a pool and an all-electric kitchen, we will run the load calculation and tell you honestly whether 200 amps or 320 amps makes sense.
Their breakers have a documented history of failing to trip when a circuit faults, which means the panel does not do the one job it exists to do. If you have one in Alabama, replacing it is the single highest-value electrical upgrade in the house.
Every Alabama city has its own electrical panel upgrade page with local pricing and booking.
Our emergency line across Alabama is answered 24 hours a day, including weekends and holidays. Same rate at 2am as at 2pm.